It’s entirely up to the user. I have just had a look at some of the zip files for other versions of the software and they contain several more files. It is frustrating as it did work on a laptop running windows xp 32 bit. Choice of pin wide-slot ZIF socket or ordinary 40 pin 0. Colin hoof Member Feb 15, The circuit uses an mcp op amp and bs p channel mosfets for clarification. It has not failed since.
|Date Added:||20 August 2008|
|File Size:||64.11 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Kit version B PCB now released. A tiny DIP switch will also work in place of the diode.
One small problem we are fixing now is the transistors blowing particularly if ICSP wires are shortcircuited. As xp is no longer supported ,I tried to set the programmer up again on a net book ,running windows 8 64 duy ,within a virtual machine running windows xp.
PIC K150 ICSP PROGRAMMER – PIC,8051,AVR ,USB PROGRAMMER,DEVELOPMENT BOARDS – alselectro
Thread starter Colin hoof Start date Feb 13, Tags k software o150. But this is definitely and option. March 23, – We have struck some problems with the V User Interface software.
Kit version A PCB. These are error messages: Please advise or if you know of a link to the correct firmware for the pickit 2 for the DIY clone project dr dejeseuss. The board is only 48 x 30mm.
PIC K ICSP PROGRAMMER – PIC,,AVR ,USB PROGRAMMER,DEVELOPMENT BOARDS – alselectro
There is even sketch of communication protocol inside the package. For example, in our Kits and we have to program one of the fuse bits RCEN to enable the internal oscillator.
This version is now sold out. I tried what you suggested in the previous post by the way and the file when opened in 7 zip keeps coming up with errors crc failed setup 1. Two DOS utilities are available for downloading to examine and reorder fragmented hex files which some compilers produce.
Unless someone out there has a working copy ,of the daypack Thank you Les for replying to my last post. I had a problem After a few years use. Yes you can use a few lines of code from the parallel port to programming the flash, eprom and lock bits. Since the same User Interface is now going to be used for Kits A and Band here is the latest upgrade which now unpacks in c: Thank you for uploading them by the way!! This will also happen when the Boards are connected and MicroPro is not running.
Chip on Board Kits Miscellaneous Links. RAR from here http: I made them variable length, in preparation for a dynamic allocation scheme, but I’m not sure at this point if it’s worth implementing.
If you gave some idea of your location in your profile there maybe someone close enough to you to program a PIC for you. There may be some information about installing the software on the kitrus website.
All the code is on floppy disk. This program corrects the Hex file so MicroPro can take it.